ScopeControl versus LightControl
During test what happens in SC
1. The sphere moves to the scope.
2. The scope passes detection lines.
3. The sphere moves back slightly.
4. The sphere moves forward slowly again to move to the right position.
5. The LED warms up.
6. When the LED is at 25 degrees C then the sphere moves to it's testing position.
7. Measurements start
8. If enabled, lens shots are taken
End of measurement.
During test what happens in LC
1. The sphere is manually transported to the scope.
2. The LC detects when the sphere is in the right place (green/red led indicator)
3. Measurements starts if the position is in the right place for a couple of seconds.
End of measurement.